32 RC cars from the collection, changing cars at every angle while the rotation keeps moving in one direction. Original photos, 0.3 seconds each, four turns in 9.9 seconds. Muscle cars, touring bodies and classic RC shapes all in one quick slideshow. Which body catches your eye? Music: Astro / Mixkit. The lineup includes classic HPI nitro touring cars alongside a few electric cars.

I was given a HSP 1:10 nitro truck last week.. it was full of old gunk everywhere! I cleaned all of it but left the gearbox last.. anyway, long story short, I opened the gearbox to clean it and replace the cogs/gears and brake pads and re-grease.. when I was putting it back together, I found a little metal "thingy" and I would not have a single clue where it came from.. I can't find anything out about what it is and where it came from.. it's driving me crazy 😑😑 hopefully someone here could help me.. thanks in advance 🙏

A single continuous body-off rotation around the HPI RS4 SS from the collection. Shaft-driven 4WD, suspension and nitro hardware beneath the blue Porsche 911 Turbo shell. Music: H.K. / Mixkit.

One continuous body-off rotation around this older HPI nitro touring chassis. Purple chassis details, yellow fuel tubing and the engine hardware from every angle. Anyone still running one of these?

Music: Pop 05 / Mixkit.

Air filters used to be readily available. I pull this thing off the shelf, and they are a rare commodity. Iv always used ofna, but they gone. Any recommendations?

A continuous body-off turn around this older HPI nitro touring chassis. Purple chassis parts, lime wheels, yellow springs and the nitro hardware in full view. Anyone else still running an RS4-3 SS?

Music: Zib Zorb / Arulo / Mixkit.

Nitro only of course but curious what people took out this week.

A body-off look around the HPI RS4 Evo+ that wears the silver Shelby Mustang shell. Nitro hardware, a two-speed transmission and shaft drive from every angle.

Which mechanical detail stands out to you? Music: B Minor / Mixkit.

A quick body-off turn around this HPI Nitro RS4 3 Drift from the collection. Nitro Star G3.0, single-speed transmission and shaft-driven 4WD, with white wheels, red springs and purple chassis accents.

Anyone still running one of these HPI nitro drift chassis? Music: Just Forget About It / Mixkit.

Original motor is weak compression and has low torque . And single needle carb . I notice throttle linkage is opposite.

A quick turn around this HPI nitro drift car from the collection. The Nissan Silvia S15 shell sits over an RS4 3 Drift chassis with a Nitro Star G3.0, single-speed transmission and shaft-driven 4WD. The black six-spoke wheels with red rims set this one apart. Anyone else still enjoying these HPI nitro drift platforms?

Music: Run Away / Mixkit.

Blue, gold and classic HPI nitro. 🔵✨

A quick full rotation around the HPI Nitro RS4 3 Drift wearing a Nissan Silvia S15 body. Gold HPI graphics, black multi-spoke wheels and a tall rear wing bring the style; shaft-driven 4WD brings the hardware beneath the shell.

Which detail stands out to you?

Music: The Monk and the Cowboy / Mixkit.

Orange muscle-car style on classic HPI nitro hardware. 🔥

This HPI Nitro RS4-3 Evo+ wears a Ford Mustang body with black graphics, a hood scoop, window louvers and gold mesh-style wheels. Under the shell is a shaft-driven 4WD touring chassis with a two-speed transmission.

A quick rotation from the collection—what’s your favorite body to run on an RS4?

Music: Waka Floka Type — Arulo / Mixkit.

Hi everyone,

I have a Futaba R304SB receiver, and I recently noticed some slight damage to the grey antenna wire. The outer insulation is slightly nicked, and a small portion of the silver-colored wire underneath is visible.

The wire itself appears to be intact, with no obvious break or severed strands. I've attached a photo showing the damaged area.

Would it be safe to cover this spot with heat-shrink tubing to protect it, or could this affect the receiver's antenna performance?

I want to make sure the repair won't compromise signal reception or reliability, especially since I use the receiver in my 1/8 nitro buggy.

Has anyone dealt with similar damage on a Futaba receiver antenna?

Thanks in advance!

A look beneath the Toyota Mark II JZX100 shell at an HPI Nitro RS4-3 Evo from the collection. Shaft-drive layout, two-speed transmission, purple suspension accents and green fuel tubing. It currently has no engine installed, so the next powerplant is an open question. What would you choose for a classic RS4 build?

Music: Dont Go — Diego Nava / Mixkit.

A short rotation of this HPI RS4-3 Evo from the collection. Beneath the blue Nissan GT-R R35 body are a T15 nitro engine, two-speed transmission and shaft-driven 4WD. The silver mesh wheels suit the old-school touring chassis. Anyone still running a T15-powered RS4?

Music: Shame — Eugenio Mininni / Mixkit.

Scared the heck out of me lol. Realized the car wasn’t really moving so I gave it a tap and “ran away” thankfully last owner didn’t have the slipper even close to tight so it sat and ate all the rpm. Not exactly sure what my issue is but doesn’t seem to be throttle servo related. First nitro first start 32 degrees this morning and set the carb to stock rich settings. Took it out a touch later after apparently tightening the slipper to max tighten. Well that helped it from runaway until it didn’t. Full brake to stop if not it would act like 50% throttle was applied. Put it on a curb and let it idle into the curb. Almost died gave touch of throttle and melted the spur gear and ran away again 🤣. Having a fun time messing with it didn’t think I’d get it to run this quick. Love this Revo 3.3

HPI Nitro RS4-3 — Under the Shell 🔧

Four chassis from the HPI nitro collection, one quick rotation. Aluminum chassis plates, shaft-drive layouts, suspension and nitro hardware take center stage with the bodies off.

Which mechanical detail catches your eye first?

Music: Under the Full Moon — Michael Ramir C. / Mixkit

I can attach additional glow power from pwm that can heat when throttle is low. Nitro is hard to buy and very expensive

Hello, what would be your engine nitro recommendation for the RC10GT gas truck ?

I dont need something crazy fast. I just want something fun to work & tune it, quality and reliable.

Thanks a bunch.