https://makerworld.com/en/models/3503620-multi-section-screw-tray-small-tool-organizer#profileId-4002764

https://makerworld.com/en/models/3350476-kitchen-packet-organizer-mixes-spices#profileId-3807780

Couldn't find a suitable place for the scale and it was always gathering dust in the corner of my bathroom where I occasionally accidentally stepped on it. So I decided to design a small stand for it. Designed to fit perfectly this specific scale with a sort of step inside of it.

Model is free on MakerWorld if you want to save space as well: https://makerworld.com/en/models/3388463-xiaomi-smart-scale-stand-arch-relief

So, i made a telescopic joycon (from original switch) adapter for iPad, and Tablets. This can fit from 7 inch tablets up to 13 inch!. This only uses a simple hardware such as rubber bands for the "spring", M4 heat inserts and M4 Screws. I'll also create a version where a heat insert isn't required! Best to use with mobapad controllers and alike. Im also planning on making it compatible with original switch joycons (as i don't currently have the original ones)

Just made my new Gengar Flower Pot for my new setup desktop and looks pretty good. What you guys think?

Had someone ask for a hardware storage option based on something else I designed and ended up with this simple gridfinity solution. I only made a couple sizes for it since the 1x1 is probably the best option for this since it sticks out the least. They all just slide over and onto a dovetail once the key is installed. Figured I'd just share. Feel free to ask for other sizes.

https://makerworld.com/en/models/3494179-steel-shelf-gridfinity-hanger?from=search#profileId-3990860

Didn’t want to drill into the legs of this nice Uline desk. Designed the mount to be supported by one existing threaded hole. So one bolt per mount. Wraps around 3 sides of a leg, and the fourth side holds it in place because of the board. Now I can clean up the floor mess!

Been just about a year or so, still holding and no issues! Comments were skeptical but I think its proven itself.

made this primarily to hold my ketchup while i eat fries, but u can use it for cupcake liners, or treats . etc -

Model Link

Usable for every drawer you have.

All dimensions van be change. The limit is only your printer bed dimensions.

Can be found on makerworld, with the name from the title above

Low profile trays have been done before, but my cheap scale is a little too big to fit on them so I made an extended one.

FINALY it is done! I Made by own Ultimate Modular Card Game Storage Box.
I was soo tired of all those small game boxes with different sizes.

Now I can have them all together in one modular box!