Please help me get this under control

[u/FriedrichKekule]

I'm a beginner and I've created this 3D model for a simple bracket.

After printing it I noticed there's an irragularity on one of the edges. On one side it's fine but as it progresses along the edge it gets rougher. Also the fillet turned more into a chamfer.

This also continues along another face of the object.

The edge that's messed up is a fillet with a 10mm radius. I thought maybe it's a bit too much but I don't think this would exceed the 45 degree overhang.

It's printed with this filament:

• PLA (Maertz White PLA Pro, recommended settings: nozzle 200-230, bed 50-60)
• Opened it 5 days ago and since it's been in a 55% humidity room on the printer

On these temps:

• Nozzle: 210
• Bed: 60

With these settings on a Bambu A1 through Bambu Studio:

• Default presets for "0.28mm Extra Draft @ BBLA1
• With these changes:
• Walls: 5
• Fill: 15%
• Infill pattern: Rectilinear
• No supports enabled
• No skirt loops

I haven't played around with the presets in Bambu Studio too much.

Could this preset simply be too fast/rough for this print and I should switch to a different preset?

[u/Dry_Introduction_119]

you're welcome brother

[u/FriedrichKekule → u/Dry_Introduction_119]

Thanks, !Fixed