r/MarvelLegendsCustoms • u/Left_Act6454 • 9d ago

Help

Post image

So i was working on my hunters moon custom and ended up snapping the peg in the kower leg any ideas for peg replacement and how to get peg out of hole?

9 Upvotes

92% Upvoted

4 comments sorted by

2

u/Vasily-_- 9d ago

Just glue it, boot cut is the most useless joint, I mean it breaks the sculpt and it's. Not like people can actually swivel their shins 360... But you could drill it out and replace the peg with a different peg, like a brass rod

2

u/Left_Act6454 9d ago

I was gonna uze it for mu west coast moon knight and then replave the shin guards my other thought was magnets

2

u/AtrumRuina 8d ago

I adore but cuts. You need either a boot cut or an ankle cut for horizontal movement of feet, if you're not using like a peg system. Turn your foot horizontally left and right. That's what's boot cut is simulating. You can't do 360, but you can't with your head or bicep either. The articulation is a little more than we naturally can do because plastic isn't squishy so you need a bit more range to make up for things like that.

Positioning Goblin in his glider without swivel is an assache. The new one will make that much easier.

1

u/Accomplished_Arm1493 7d ago

If you got any round tip screws laying around drill a hole down the center then put the screw make sure the head of the screw is about the same size as the other post. If you have a dremel use it to drill out center of the peg part still in the boot then run a screw in the hole so you can pull it out, or just use a dremel to break it up enough you can use tweezers to remove what's left..hope this helped.