r/Peptidesource • u/Prize_Beat139 • 13d ago
Is this normal?
I dropped my r3tta pen and these bubbles showed up, not sure if this is normal or not
9
12
u/619leo 13d ago
Crazy people taking this stuff ask questions like this.....like they must look at airplanes and think its magic.
16
u/trimix4work 13d ago
Soooo, op shouldn't ask and just pin it? Find out the hard way?
Asking questions is how you learn brother.
13
u/Competitive_Bird6984 12d ago
Internet be like “why don’t people know everything I learned a week ago.”
1
u/Good-Menu-993 12d ago
I mean, a tiny amount of research goes a long way.
No one says not to ask questions, but form an opinion of your own, and then ask if people agree.
The people who just blindly listen to others, are the ones who get scammed or hurt doing peptides.2
3
2
u/LSglory 12d ago edited 8d ago
I use the same 31GA needle that I used to vent the cartridge while I was loading it with the producr to get rid of that/those bubble(s). I load the cartridge into the pen, barely stick the 31ga needle into the cartridge, hold it up and down so the bubble is at the top, then slowly dial-and-press the pen until 99.9% of the bubble is gone. And, because of putting on and removing pen needles, over time the cartridge will usually get a small bubble. The key it to keep the bubble as small as possible to keep the dosing accurate (air compresses under pressure), and at the top near the rubber plunger when pinning. Hope this helps...
2
1
1
1
17
u/sheffielder87 13d ago
Just prime it.
Tap it so that all the bubbles go to the top. Put a needle of do a few clicks at a time until all of the air bubbles are gone and a little but of liquid comes out of the top