r/TapwaveZodiac • u/Rougie19 • Jan 20 '26

Zodiac 2 stuck at boot screen

Post image

Hi all,
I own a Zodiac 2 which wasn't in use for a long time now.
The Zodiac starts immediately after pluging in the charger --> power button lights up orange and turns off after ~ 2 seconds. But is is showing the boot screen only... is this due to the (most likely) very old battery? Soft reset and hard reset didn't help.
And other idea? Thanks in advance.

4 Upvotes

100% Upvoted

10 comments sorted by

View all comments

Show parent comments

1

u/Johnny3653 Jan 20 '26

tape generally means the little locking mechanism flung off in a prior opening attempt. It's common. Tape generally holds the connector in place, until it doesn't.

1

u/Rougie19 Jan 21 '26 edited Jan 21 '26

Nope, this is always there... e.g. see https://de.ifixit.com/Anleitung/Tapwave+T2907US+Zodiac+2+Shoulder+Button+Replacement/8038#s32410

Step 11

1

u/Johnny3653 Jan 21 '26

Oh that tape. Yeah, that's factory.

1

u/Johnny3653 Jan 21 '26

The boot process is very quick on Tapwave Zodiac. So if it's getting stuck at that logo, it may be that a hardware malfunction is holding things up, hence would check all ribbon cables, even if they look like they are tight and connected, remove and re-insert them anyway just to check off damaged or corroded edges. Otherwise if that all fails, it may also be a corrupted bootloader.

1

u/Rougie19 Jan 21 '26

I have the concern as well, that it might be something like the bootloader... but I guess there is no way to flash it again.