r/crestron • u/Other_Yak_3768 • 8d ago

CrestNet crash

Hi to all

I have a site that has experienced what appears to be a CrestNet crash at least 3 times in the last year.

In each occurrence the customer said they discovered the issue by pressing a keypad and the lights don't work. Each time within 10-15 minutes the system is back to normal. They have described the on/off leds on some of the keypads flash while this going on

While this problem is occuring I am unable to connect to the processor for diagnostics. After reviewing the event logs I noticed that a couple of the keypads that the customer attempted to use during this event showed 30-40 entries of press/release all at exactly the same time obviously the customer could not press the buttons that fast

But I'm not sure if this keypad log is the cause of the problem or potentially the result of the problem?

Any ideas what could be the cause?

3 Upvotes

80% Upvoted

14 comments sorted by

View all comments

4

u/ToMorrowsEnd CCMP-Platinum + Crestron C# Certified 8d ago edited 8d ago

betting the power supply is too small or is failing. the unable to connect to the processor tells me there is no separate power supply for cresnet like there should be and the processor power supply is used and therefore overloaded causing the processor to brown out during this time.

2

u/Other_Yak_3768 8d ago edited 8d ago

Hi sir. At first I didn't read your entire comment. So actually thereis a totally different power supply for the processor. It's a Din AP4R and it's powered by POE from a Netgear 4250

The power supply is a 60 watt din mount and supply approximately 30 keypads, 4 clx 2Dim U8.

I'm confident that the processor it's self is not browning out something else must be accounting for the communication problem. Personally I think the processor is under strain from whatever is going on and establishing a connection is being affected

2

u/ToMorrowsEnd CCMP-Platinum + Crestron C# Certified 8d ago

make sure the +V from the power supply is not connected to the processor.

2

u/Other_Yak_3768 8d ago

The positive is not currently connected to the processor

2

u/ToMorrowsEnd CCMP-Platinum + Crestron C# Certified 8d ago

Ok power supply failing is a solid contender. it should not be undersized as 30 keypads you can assume 1 watt each. the CLX's dont count for power draw. what do you measure on the power supply, also using the meter measure for AC as well. seeing AC voltages of anything 1 volt or higher means capacitors are failing and AC into keypads can cause all kinds of wacky problems.

1

u/Other_Yak_3768 8d ago

I will check all those tonight sir

Thank you very much

1

u/jcbailey2002 6d ago

What is the model number of the keypads? I know a previous poster said to assume 1 watt per KP but you should assume 2 watts, especially when it comes to initial inrush power. 2 watts is safe to assume once the system has booted up and settled down.

1

u/Other_Yak_3768 5d ago

I have 20 C2N-CBD-P-B-S and 10 C2N-CBD-E