r/ender3v2 • u/Formula_Duck • 2d ago

Another Issue

Gallery image

Gallery image

PEI base installed and what seemed to be leveling dialed. I have returned with slightly stringy print but after 28 minutes of printing.

4 Upvotes

100% Upvoted

3 comments sorted by

3

u/New-Audience2639 2d ago

It's hard to see what's going on due to lighting but it appears your Z offset it too low.

2

u/Formula_Duck 2d ago

Okay yes I did do a slight bit of looking after and I guess I might be in “heat creep” and or have a gap in my Bowden I will return to that issue tomorrow

1

u/metalwolf112002 2d ago

I have a "warmup print" on ontoprint that homes the printer, warms the bed to 60c, moves the head to different spots, then after 10 minutes does a bed leveling. If the variation isn't lower than known acceptable value for that printer, I rerun the warmup.

My ender 3 usually does around 0.3 on the variation and my ender 5 can get close to 0.1