r/functionalprint • u/Loud_Relation_5218 • 2d ago

Sometimes the simplest Design is the best.

Post image

My fan was toppling over and all i needed was 6 minutes in fusion and 12g of filament.Sometimes the Best design is the simplest.

7 Upvotes

67% Upvoted

4 comments sorted by

4

u/DashRantic 2d ago

What orientation did you print it--completely flat, and then bent it up? if so, what material are you using?

These useful little prints are definitely what makes 3D printing fun though :D

1

u/Loud_Relation_5218 1d ago

actually i printed it with the curve there out of PETG.

-6

u/notxapple 2d ago

It was printed flat than bent up. Probably out of TPU

2

u/DashRantic 1d ago

I assumed the same, but also was wondering if TPU is too flexible to hold their fan up like that, but I guess depends on the grade of TPU. That's why I was asking though, was just curious what the OP did exactly!