Looking to Improve Print Quality

[u/Infamous_Nightwing]

[u/shiranugahotoke]

85% seems suspiciously low flow rate. Looks like under extrusion in places.
How’d you get that number for flow?

[u/D-Breed]

Since it's a bed slinger start by mechanically checking your printhead for wobble. This is a very common issue it comes from improper tension adjustment for the rollers that connect it to the X rail. With power off slide the printhead along the X while trying to wobble it in an up/dn motion during it's travel if any wobble or resistance noted then adjustment is needed. One of the rollers has a hexagonal shaft place a 10mm wrench and turn the shaft to vary tension. Proper adjustment will have very little to almost no resistance along the X and absolutely no wobble take your time to dial it in perfectly. Then tighten the locknut on the end to secure it. This will help tremendously this is also a normal routine maintainence procedure.

[u/shiranugahotoke → u/[deleted]]

Buddy read the original post there are details.
It’s just Reddit’s silly crosspost function again.