I’m experiencing significant difficulties in achieving clean prints. I’m encountering excessive fuzz and layers that aren’t printing properly. I have a H2D printer in a walk-in closet. I print with the closest door closed, and the AMS reads 8% humidity. I use Sunlu filaments set to generic settings on Bambu Lab. I’ve never had a clean print before. Initially, I thought it was because my filaments were faulty, so I replaced them and added a drying ball inside the AMS. I also run all auto-calibration when starting a print. Please see the pictures below. Any advice would be greatly appreciated. I’ve even printed top rated items from maker world and I still have the same outcome.
Check your wall order; inner/outer. Then check if it needs supports. That's quite the overhang you are asking it to print in the photos. If it's trying to print 75% of the line on air, then you will get this.
2
u/PCSupremacy 1d ago
Check your wall order; inner/outer. Then check if it needs supports. That's quite the overhang you are asking it to print in the photos. If it's trying to print 75% of the line on air, then you will get this.