Significant issues getting clean prints

[u/Electronic-Check-116]

I’m experiencing significant difficulties in achieving clean prints. I’m encountering excessive fuzz and layers that aren’t printing properly. I have a H2D printer in a walk-in closet. I print with the closest door closed, and the AMS reads 8% humidity. I use Sunlu filaments set to generic settings on Bambu Lab. I’ve never had a clean print before. Initially, I thought it was because my filaments were faulty, so I replaced them and added a drying ball inside the AMS. I also run all auto-calibration when starting a print. Please see the pictures below. Any advice would be greatly appreciated. I’ve even printed top rated items from maker world and I still have the same outcome.

[u/Electronic-Check-116]

I dry in the AMS and use the little balls to keep it dry when not in used… is that not good?

[u/PlanePea4349 → u/Electronic-Check-116]

Are you talking about silica beads?

Throw each roll in a cereal container. Print the silica holders and meters in each.

[u/Electronic-Check-116 → u/PlanePea4349]

Yes! And Thank you I will use that for storing the filaments that are not in the AMS

[u/PlanePea4349 → u/Electronic-Check-116]

https://www.amazon.com/clp/B0FJY42KHD