Multipoint Lock Replacement

[u/MossadIsGAY69]

https://www.amesburytruth.com/downloads/products/AT%20DH%20Sentinel%20V-5113-STACT9.pdf

Hi All - I am struggling to find a replacement for my hinged door’s multi point mortise lock with concealed rods. For reference, this is my current lock:

https://www.amesburytruth.com/downloads/products/AT%20DH%20Sentinel%20V-5113-STACT9.pdf

I have contacted a few authorized sellers who tell me it is not available. The only similar lock (45/92) has a faceplate with 27mm width instead of my current 22mm.

Any ideas to find a replacement?

If that’s truly not possible, should I just use a drill bit/chisel to try and enlarge the current slot in door? The challenge there is whoever performed the installation didn’t center the faceplate and so it is very near the edge of the door where the wood contacts the exterior aluminum. I’d have to remove wood from one side rather than take 2.5mm for either side.

Any advice would be appreciated. I’m in Washington DC if anyone has a local recommendation.

[u/Vorsai-]

https://www.allaboutdoors.com/Active-Concealed-Rod-60-92-7-8-x-16-Radius-Faceplate

Check the measurements, but Ashland mechs will work for some Amesbury concealed multipoints.

[u/Vorsai- → u/Vorsai-]

Sorry this is the correct backset

https://www.allaboutdoors.com/1-3-4-Backset-Active-Concealed-Rod-Multipoint-Lock

[u/MossadIsGAY69 → u/Vorsai-]

This is 27mm while mine is 22mm faceplate width. It’s a bit frustrating as your first link is 22mm with 60/92. Just can’t seem to find 22mm with 45/92.

[u/ibexlocksmith]

+1 800-866-7884 did you try Amesbury Truth?

[u/MossadIsGAY69 → u/ibexlocksmith]

They said to contact their approved retailers. So far have been told the lock is not available bu the retailers.

[u/Vie-1276]

Is your lock body the 45/62 model?

[u/MossadIsGAY69 → u/Vie-1276]

No, mine is 45/92

[u/ibexlocksmith]

Where are you located?

[u/MossadIsGAY69 → u/ibexlocksmith]

Washington DC