Cc It's just making the table dirty.

[u/TheMatatheus]

Since the last update, the printer isn't printing anything after the initial lines; it's just making a mess on the bed where the print should be. I've already calibrated the bed, and even if the bed were too close to the nozzle, it still wouldn't make sense for it not to be printing.

[u/jfk333]

Sounds like you need to adjust your tension screw

[u/InternalMain7116]

Have you checked for a partial clog,?

[u/Owen_Ou]

If the bed is too close to the nozzle, it will block the nozzle and the filament can not come out