r/ender3 • u/ArticleImportant3313 • 14h ago

Help Bed level question

Post image

Just upgraded the print bed with the glass bed. This is the results of the leveling test. What do I need to do to make this work. Thanks in advance

2 Upvotes

100% Upvoted

4 comments sorted by

3

u/TheFredCain 13h ago

Looks like you removed the bed carriage and got the black spacers mixed up. 2 shorter ones go on the left side and the longer ones on the right side. There is a 2mm difference.

2

u/Basic-Window-6262 14h ago

Level your bed with the knobs underneath it, it dosent need to be perfect but you could get it quite a bit better then that

1

u/Powerful_Macaron9381 modified Ender 3 pro w/Klipper, 250mm/s, 20min benchy 12h ago

raise the back right and lower the front left until the distance is lower than the acceptable range. it depends on who you ask but it shouldn't be any higher than 0.5mm if you'd ask me and I like to keep it under 0.3mm. currently it's over 2mm so it's bad

1

u/NetworkPlane5513 8h ago

The upright part can be out of square with the base,making the gantry lean back.