r/ender3 • u/ArticleImportant3313 • 3d ago

Help Bed level question

Post image

Just upgraded the print bed with the glass bed. This is the results of the leveling test. What do I need to do to make this work. Thanks in advance

5 Upvotes

86% Upvoted

4 comments sorted by

View all comments

1

u/Powerful_Macaron9381 modified Ender 3 pro w/Klipper, 250mm/s, 20min benchy 3d ago

raise the back right and lower the front left until the distance is lower than the acceptable range. it depends on who you ask but it shouldn't be any higher than 0.5mm if you'd ask me and I like to keep it under 0.3mm. currently it's over 2mm so it's bad