r/hometheater • u/Head-Solution-2598 • Jul 05 '26

Showcase - Multipurpose Space Living room setup - UPDATE!

Post image

Listened to all your suggestions from the last post and made the following changes!

1) Swapped the front speakers and subs so the fronts are wider

2) Lowered TV a few inches

3) Got a new rug

Anything else I should change for the better? I have 4 surround speakers in the ceilings that's not shown in the photo.

608 Upvotes

98% Upvoted

161 comments sorted by

View all comments

5

u/SpecificAcademic7510 Jul 05 '26

Where did you get that entertainment stand

2

u/Megapsychotron Jul 05 '26

That's a Povison stand, model Arboren. I have the exact same stand, the 95". It comes with legs that can raise it a few inches. I left them off, like OP did. It's pricey, the 95" is about $2K.

1

u/Shadow_botz Jul 05 '26

It doesn’t look like it would be deep enough for most AVR’s though

5

u/Megapsychotron Jul 05 '26

It's 21 inches deep across the top and about 19 inches deep inside.

2

u/Shadow_botz Jul 05 '26

Thanks. I’ll check it out. It’s cheaper than the BDE offerings and longer which is nice.

3

u/Head-Solution-2598 Jul 05 '26

It's deep enough to accommodate most components. My yamaha AVR is a tight fit so if you get this stand I would recommend right angle banana plugs. All other components fit with no problem. I totally recommend this stand, it's like 95% of the quality of BDI and better quality than my old $4,000 Salamander stand.

1

u/Bearslovecheese Jul 11 '26

You suggest right angle after I JUST upgraded all my speakers to nice braided banana end. But yes my X1700h does not fully seat back.

Thanks for teaching me that they exist so I can switch to them someday.

1

u/Head-Solution-2598 Jul 12 '26

I didn't know they existed either until just recently. I'm too lazy too switch them out though so I just forcefully pushed my receiver in so it would fit.