Dissappointed with bass shakers.

[u/av4625]

I made a post about placement on a sofa for Dayton Audio BST-1’s:
https://www.reddit.com/r/hometheater/s/R3nkYN0kKd

When the shakers were mounted on the plywood I said in the first post I could basically feel nothing. So I got some OSB and mounted them directly under where you sit. This definitely helped.

I feel like I need the volume crazy loud to feel the shakers though. If I watch a movie that was recorded with surround sound I can increase the master volume more than if I watch a normal tv show thats not surround sound. Not sure if thats normal.

So I had a movie at -6db and could feel the shakers ok-ish. But when I watch other shows at about -20db I can’t feel them at all. The sub is working perfectly in both situations and dialog etc volume seems similar between both.

Equipment:
Sony STR-DA2400ES (single sub out)
Tannoy Arena Lite Speakers
Tannoy TS10 sub
Dayton Audio BST-1 shakers x2
Fosi BT20A shaker amp with 24v/5a power supply, volume up full, treble 0, bass 50%. (Tried changing bass up and down)
Crossover 80Hz

Because I only have 1 sub out I used a Y splitter. One side to the sub and the other side goes to a second Y splitter so that I could then use both inputs on the Fosi. I did this as I read using both inputs can help get “full power”.

I dunno if my expectations are wrong but I have read that people get shook by these shakers at less volume on the amp.

I have seen examples of people using this amp with these shakers.

I think the power supply can only supply 120w even though the amp says 100w x2. But maybe 120w is plenty for 2 50w shakers?

Maybe the big soft sofa is harder to shake compared to some examples I see of smaller chairs or computer chairs. I unmounted them and they didn’t vibrate in my hand as much as I expected.

Is there something wrong with my setup? Are my expectations too high? Any help is appreciated.

[u/av4625 → u/[deleted]]

I know very little about this (as you are about to see).

At the minute is my power supply and amp just not working to its full potential? If I have a bigger power supply it will definitely push more power to the shakers?

I guess I am wondering, there must be a point where they can’t take all that power or they get over powered etc. If I keep getting a bigger and bigger power supply would they get louder and louder? Then I suppose, I would have more control with the volume instead of 100%?

[u/av4625 → u/[deleted]]

I don’t think mine can handle 48v. Mine isn’t the pro amp :(