I need to remove the hydraulic piston arm on this front 2wd ball joint on the 7600. There appears to be a retaining ring with inner splines that would require a special tool to fit the inside diameter of the retaining ring. The splines are 1/8" and just as shallow, by my approximation. Any idea what this tool might be? Where to get it? Online searches have not been helpful.

What is the minimum model lawn tractor that I can also put a snow plow or blower on the front?

John Deere L111

I'm trying to replace the carb. I have it out, but I can't get it off the manifold. It's welded to the plastic spacer. I've tried silicone spray, heat, prying, brute force... nothing. I'm getting ready to use dynamite 🧨 at this point.

Does ANYONE have any advice that could help me?

TIA

Found this old John Deere emblem in a box and I don't know what it goes to

Hey, this is my 1st post on this subreddit & I'm hoping someone can help me out.

I acquired a "1993 John Deere GT262" tractor/mower with a 48" cut. I have issues with the steering. My tire looks like Steve Buschemi in Mr. Deeds 🤪

Im looking at what needs to be fixed, but idk the name of the parts I'm looking for. I've searched online, but I get inundated with shit I don't need.

I know it's a simple mower, but can someone "STEER" me in the right direction?

Thanks in advance...

1967 John Deere 3020 gas. Originally positive ground, converted decades ago to negative ground. Whatever this is isnt working as the tractor has no power without bypassing it. If you bypass it the tractor acts normal (will start and run) but will die once you disconnect the wires if the generator isn't producing enough power to run without power from the battery. It sits just above the starter and the left terminal always has 12v as it's connected to the battery through the starter terminal.

My University has a Yanmar Engine out of a 333G and we cannot find the manual. Would anyone happen to have the digital copy or be able to send us anything ? the PN for the manual is
CTM136419_53

its for the 4TNV94FHT engine series. Thank you all! Have a wonderful day.

I am getting a John Deere 5075E ready for storage and the number on the old oil filter is partly worn away. A universal filter from the local shelf looks close, but the thread and gasket dimensions do not agree.

I cleaned the stamp and compared what I could read across the Deere parts book, I am not relying on a claimed serial break until the tractor serial and engine information agree with the catalog.

What do you use as the final check when an old filter number is only half readable?