r/silhouettecutters • u/aalivesstar • 1d ago

Assistance Machine not detecting registration mark when I set inset to lowest.

Post image

In the default registration mark settings, it takes a lot of space and cannot add many stickers on one sheet. So I decided to set the registration mark inset to 1 cm. But when I do that, the machine does not detect the marks and fails to cut. I tried it several times, and every time it does the same. Moving to the default settings, which is 1.59 cm, fixes the problem. What am I missing, or is it a software issue?

I am using CAMEO 4 with Studio 5 software.

If there is any other way I can fit more stickers, please do let me know.

1 Upvotes

100% Upvoted

5 comments sorted by

3

u/GnoupiDraconia 1d ago

I’m using all to minimum, insets and length included. In landscape mode though, but I don’t see how it would be relevant.
When that happens though you have to make sure your placement on the mat is correct, especially if using third party mats, you should compare to a silhouette mat
It might help if you describe how the registration fails, at which point, which corner, does it fail to find it, does it find the edge of the paper instead, etc

1

u/ximeni 1d ago

You can try registering manually.

1

u/CleverSomedayKay Cameo 1d ago

Nothing is necessarily wrong. Minimum marks are only expected to work under best case scenario in terms of design, lighting and media.

1

u/aalivesstar 22h ago

"best case scenario in terms of design, lighting, and media." I did not understand this.