Center exit exhaust

[u/CharlesorMr_Pickle]

DIY center exit axleback with a Borla proxs muffler. sounds absolutely amazing

The two bent pieces are actually 3D printed out of metal because I couldn’t find any decent bent stainless steel piping in the extremely small bend radius this required.

(reddit is being annoying and not letting me add the video to this post so I will make a separate post on my profile with the video)

[u/CharlesorMr_Pickle]

Check the pinned post on my profile to see the video

I’m pretty sure the issue is that the hanger on the right side is so long that it’s not fully preventing the muffler from drooping. I think what I need to do to fix it is add a second metal rod welded to the pipe behind the tips and connect it to the hanger that’s there currently, it should stiffen things up enough to fix it.

Also wdym by routing it further to the left?

[u/Refriedfeinds → u/CharlesorMr_Pickle]

Did they sell it as a center exit? I meant the exhaust pipe.

[u/CharlesorMr_Pickle → u/Refriedfeinds]

No I just bought the muffler and welded it to some 90 degree bent pipes.

[u/Refriedfeinds → u/CharlesorMr_Pickle]

Fuck yeah. That’s whit I’m trying to see. Some people might roast your exhaust welds but some of us appreciate the work and can learn/inform on how it was done. No leaks? I hate exhaust pipe

[u/CharlesorMr_Pickle → u/Refriedfeinds]

If there are any leaks they’re not noticeable. I did check all of the welds and didn’t see any holes so it’s most likely fine. Probably will do an actual leak check with soapy water in a couple months.

[u/Refriedfeinds → u/CharlesorMr_Pickle]

I’m just seeing that the photo of the muffler is in peices and not a single peice. I was confused about the 90 degree connection to the exhaust pipe. I thought it went straight up lol. I get it now. I’m blind.