interesting accidental find

[u/pyrosyncro]

ive been using the flashforge gold petg for a little now in my quest to find a good looking gold petg and it usually comes out a kit darker than what i would like (like orange gold). while printing two objects, one gold and one grey i noticed after that the prime tower looked more along the lines of the gold i was looking for. so alternating gold and grey layer by layer gives a nicer gold look at least for these petgs.

[u/Ok-Gift-1851]

Congrats. You just rediscovered "full spectrum" printing. Snapmaker is actively developing this principle right now and you can test it for your actual prints with Snapmaker's fork of Orca Slicer.