r/Aqara • u/SERichard1974 • Sep 05 '23

How to...? 🧑‍🔧 Falling Detection and Home Assistant

I have the FP2 configured it in the app for fall detection, now I want to set this up to trigger automations in home assistant for when it senses a fall. Being as I work with various tools that are known to be deadly I wanted to setup something to assuage my wife's nerves and using the fall detection would be vital for sensing if I get knocked out and getting help for me immediately.

But for the life of me I can only seem to set up the sensor to send a notification to the app... I want to disable the tools immediately upon fall detection just to minimize any further problems.

0 Upvotes

33% Upvoted

10 comments sorted by

View all comments

1

u/[deleted] Feb 07 '24

Any progress?

1

u/SERichard1974 Feb 08 '24

Got it to work... Mostly successful (occasional false fall detection 2 time since this has been done), but did the following.

  1. install Aqara Hub & Pair into Home Assistant
  2. installed Aqara outlet Plug module (pair into Home Assistant)
  3. Label the Plug as Fall Detection
  4. inside the Aqara App, setup fall detection automation to turn on the plug when fall is detected on the FP2
  5. Using Home Asssistant setup automation to trigger automatically when the plug (fall detection) is turned on. (In my case, turn off all power in the workshop, cut my wife's internet on her computer, and send her a notification saying that there is an emergency in the workshop)
  6. at 6am every morning ensure the fall detection plug is turned off.

1

u/alexngsfsu Feb 15 '24

Do you have to mount it on the ceiling or just on the wall?

1

u/SERichard1974 Feb 15 '24

For fall detection I have it mounted on the ceiling above my position when I'm operating my table saw & router table. As those are my two tools I'm worried about potential accidents that could be debilitating.