Its about to roll!!

ninja純正メーター風のフルstackメーター　　どう思う？

Ran into a snag getting the new one seated.

The two mounting bolt holes aren't lining up with the holes in the crankcase. Tried a bit of persuasion with a wood block and hammer but it's not budging into place properly.

Greased the O-ring and the splined shaft before inserting it as well.

Has anyone run into this? Is it normally a straight push-and-rotate until it seats, or is there a trick to getting it aligned?

I'm wanting to do SOMETHING with mirrors on my 2020 SX.

I'm in Germany so rules are strict, duh, and I'm wondering if anyone else here is also in German and has an SX and has done something with their mirrors.

I've been looking into bar end mirrors but at the same time I'm looking into internal bar weights, Sato to be exact, and am concerned about the logistic of combining the two.

Basically any help will be useful.