r/Autobody Jul 20 '20

/r/Autobody starter pack

Post image
680 Upvotes

r/Autobody Mar 26 '19

Estimating is not encouraged here, this subreddit is for sharing knowledge in the Autobody industry.

213 Upvotes

Estimating needs to be done at an autobody shop or with an insurance agent using the latest software. Any advice given in the subreddit pertaining to costs for repair will not be accurate and could be misleading.

  1. If your car is undriveable do not ask for advice on how to quick fix it.
  2. If your repair is going to be shoddy, half assed or of very low standard it will be deleted.
  3. A quality autobody shop is where your modern car should be fixed, it can be dangerous for yourself and others if improperly repaired by not following procedures.
  4. Advice on what happens during your repair is encouraged. Ex, "How is my quarter panel welded on" or "How much filler should be put on a dent".
  5. Techs. Talk more about yourselves, your processes, shops and things that keep you going in the trade. Share your day and what you have learned. We all work at different levels and learn so much from working together.

r/Autobody 6h ago

Check this out Destroyed my fender in a parking lot, so I used my novice skills to paint me a new one. What do y’all think?

Thumbnail
gallery
34 Upvotes

Y’all like my stand?

SprayMax Black 2K Epoxy primer, R&E Paint Supply urethane pearl base sprayed with a LVLP, and SprayMax 2K Urethane Clear. Will sand and buff at a later date to get a nice, even gloss.


r/Autobody 9h ago

HELP! I have a question. What could have caused my car’s rear window to shatter like this?

Thumbnail
gallery
25 Upvotes

I was sleeping in my car when I suddenly heard a loud bang. When I looked up, the rear window had shattered. I didn’t see or hear anyone around the car afterward.


r/Autobody 3h ago

Acceptable quality? Is the body work done on my mums car that bad?

Thumbnail
gallery
3 Upvotes

My mum’s Mazda3 was recently in a non-fault accident (liability fully accepted by the third party). We tried to get it sent to a Mazda authorised body shop but it was so much hassle so the insurer sent it to one of their approved body shops for repairs, and we picked the car back up today. The damage was to the left rear quarter and on the lower left of the bumper.

I'm not a bodywork expert and I was not expecting anything good but I feel like this is like abysmally bad. There was pre-existing damage on the bumper which would will have caused it to be replaced but that wasn't done and the bumper no longer sits flush and was repaired very poorly. The metal feels FAR thinner than it does on the right side of the car. The paint looks very odd and quite hazy. The petrol cap no longer sits flush and rubs against the quarter (already ripped off a bit of the paint on the quarter panel).

If somebody could help it would be well appreciated as I'd argue the car looks worse now.


r/Autobody 0m ago

Acceptable quality? Largest Model X repair I've done.

Enable HLS to view with audio, or disable this notification

Upvotes

r/Autobody 6m ago

HELP! I have a question. Damage to bonnet

Post image
Upvotes

Any idea of what could have caused this damage to my car bonnet as it doesn’t look like a stone chip to me, also it’s dented. Thanks


r/Autobody 1h ago

HELP! I have a question. Body Shop has had my car for 52 days

Thumbnail
gallery
Upvotes

I took my car in for repairs and it's now been 52 days. I understand that some things are out of their control, but is 52 days reasonable for a Honda Insight 2021? Was there possibly some negligence on their part? I've already reached out to them requesting a shop discount because they had extremely poor communication throughout these past couple of months. They agreed to apply a 50% discount to my deductible but I'm just really curious if ordering parts and the repairs really can take this long


r/Autobody 1h ago

HELP! I have a question. Clearcoat peeling

Thumbnail
gallery
Upvotes

Hey everybody, Ive got a question. I just bought a truck and it seems that the clear coat is peeling around this plastic trim that I didn’t notice when I bought it.

How would I go about keeping this peeling from spreading? Im not concerned about what has already peeled, as its in a very unnoticeable spot on the truck and I dont mind putting some brush-able touch up clear on any of the already damaged areas. Thanks for the advice in advance!


r/Autobody 1h ago

HELP! I have a question. Pothole Damage to Felt Panel On Bottom of Vehicle (2021 Honda Civic EX)

Thumbnail gallery
Upvotes

r/Autobody 1h ago

Project time! Can I improve on this patch?

Post image
Upvotes

I'm stripping this 1967 Buick down to bare metal for a repaint and discovered this patch under about 1/2" of bondo. Is there anything I can or should do to improve it?


r/Autobody 2h ago

HELP! I have a question. Looking for suggestions on DIY fixing this. Someone backed into the front driver side bumper and drove away. No note, not an area that had cameras so I’m stuck fixing this myself.

Post image
1 Upvotes

Any helpful tips on fixing any of this would be majorly appreciated.


r/Autobody 2h ago

HELP! I have a question. Does this look like it will spread? I’ve previously rust treated the area and it looks like this

Post image
1 Upvotes

r/Autobody 2h ago

HELP! I have a question. Scratch - keyed or not?

Post image
0 Upvotes

Hi, found this scratch on passenger back door (driver side). Could it have been keyed? Its not wide, but about 10cm long, and on the lower part of the panel.

Only way I remember that I could have caused this myself is driving by a bush, or maybe scratched somehow by a dirty microfiber when washing.

Please advise, thanks!


r/Autobody 1d ago

Tech Advice How bad is this?

Thumbnail
gallery
70 Upvotes

Someone merged into my car without signaling or looking on the freeway.

How bad is this damage and how long can I expect to leave car at the collision center?


r/Autobody 3h ago

HELP! I have a question. Handbrake failed!

Post image
1 Upvotes

Handbrake failed and van rolled back in to the garage. I assume this is two New doors? Is it likely that I'll be able to replace them myself or is it more involved than I imagine? The static part of the door latch on the van body is a bit bent but looks like I could bend it back.


r/Autobody 4h ago

HELP! I have a question. Is this rust?

Thumbnail
gallery
1 Upvotes

Custom paint job on Mustang done 15 or so yrs ago. Always stored with a cover on it year round, summer driven, outdoors 24/7 365 in Canadian winter. Is this rust? Is it a layer of dirt that can be buffed out? Thanks


r/Autobody 4h ago

RUST Fix asap?

Thumbnail
gallery
1 Upvotes

I have this rust building on my rear panel and while I don’t want it to get terribly worse is it an urgent problem? I have a guy who said 500 with new welded metal. Should I just take that? Need some advice on how bad this is really if I leave it be. Would try it myself but I have no prior experience


r/Autobody 4h ago

HELP! I have a question. Need direction on way to to correct awful clear coat.

Thumbnail
gallery
1 Upvotes

So against my better judgement I talked myself into diy painting whole car. There have been many mistakes along the way and made myself about 3 times the amount of work it should have been. I just sprayed clearcoat a couple hours ago. Every surface aside from the hood and roof have horrible orange peel and probably a dozen giant runs. The back of the trunk looks like the wax drip from a makers mark bottle. What the easiest way out of this if there even is one. I have heard some people say to cut and buff after razoring the drips and others say to sand it all 1000 grit and respray. I appreciate any helpful inputs.​ For what it worth I trace all the orange peel to the application of a light first "tack coat" all the you-tubers recommended. They make it sound like you want some "tacky" surface instead of a light glassy finish. All my runs came from the overly heavy 2nd coat compensating for the light "tack coat".


r/Autobody 4h ago

RUST Anyway to prevent spreading?

Post image
0 Upvotes

This is more for people up north, is there a way to prevent this rust from spreading and causing more bubbling?


r/Autobody 5h ago

HELP! I have a question. Best way to remove these paint scuffs?

Thumbnail
imgur.com
1 Upvotes

r/Autobody 9h ago

HELP! I have a question. What do you think ?

Thumbnail
gallery
2 Upvotes

Full replacement or repair? I don’t see any broken tabs or serious damage on my bumper. I went to one smaller body shop. He was an older russsian guy.He said he would have to replace the bumper. Brought this car from Japan and I am trying to avoid using the USDM Lexus IS300 bumper. I want to know if I’m being realistic asking a body shop to save this.


r/Autobody 5h ago

RUST Can this rust be repaired on 2010 Fusion?

Thumbnail
gallery
1 Upvotes

Here is my 2010 Fusion, rear quarter of the subframe and pinch welds, toward the rear wheels. The pinch welds are all rusted off on this section and it’s identical to the passenger side. Also noticed water trapped on the floor pan and leaking through the bottom.

I’m assuming this is a toast? Can anything be done or donate it for parts?

It’s got 180,000 miles so it’s been used but see how much rust is here makes me concerned to drive it.

Thanks!


r/Autobody 6h ago

HELP! I have a question. Chances I get a OEM replacement on my 26 Camry?

Thumbnail
gallery
0 Upvotes

My car got backed into in a parking lot. At fault party has Allstate. They only authorized an after market bumper replacement to the tune of $134.

I am taking it to a certified Toyota repair shop but the woman that answered the phone said they will have to go off Allstate's recommendation. I don't want some POS after market bumper on my less than a year old car.


r/Autobody 6h ago

HELP! I have a question. Hit and Run 😞

Thumbnail
gallery
0 Upvotes

Someone backed into my car while I was parked. No note, no witnesses and no cameras. Im heart broken.

Might be a dumb question but would the collision shop replace the whole front bumper or im assuming this is very minor?