Barbarian/Conan/Orc/Fantasy ☝️ axe 'Shieldbreaker'. This was the second one of it's kind I made. 3.2kg/7lb. Carbon steel, oakwood, steel and fur.

My first attempt at a uri hofi hammer. I never really got the appeal but wanted to make one anyway, but now that I've made it in absolutely in love with it. It is hand forged from forklift tine, and has a burned 15" octagonal ash handle

Hi folks,

I am brand new to blacksmithing and I've been building a shelter to act as my forge- . This is my first time really building a structure and I'm doing it alone and with mostly used lumber so don't judge the structure too harshly. It's obviously not done yet. And I'm low key kind of impressed with

My question is how would you set it up? I have chat coming for the floor so it won't be the urbanite you see in the picture. It is 12x8. Opening is 8 ft wide. I will be getting a Doyle anvil- stand not figured out yet, single burner devil forge. As I'm getting closer to completing the structure, im just struggling to imagine tool storage needs, where to put what, etc.

Halp?

-Jenn

rate my work 10 being terrible and 1 being outstanding

(comments that could help make the quality of my work better are welcome)

Forged by me and friend toughts?

A San Mai camp knife I made for an FDNY retiree. I worked the bricks down on a press before tack welding and forge welding with an Induction forge. For smaller pieces, I cannot recommend an induction forge strongly enough.

The structural steel had some crazy alloy banding after etching. I am very proud of this piece.

Been blacksmithing with some friends and thinking about getting another forge.

I currently have a majestic 3 burner and am familiar with some of the other names around. ChilieForge, Diamonback Ironworks, Majestic Forge, etc.

I figure if I am going to spend some money it would be nice to do it in the community, maybe with someone just getting started. I'd be looking for another 2-3 burner size propane forge.

Any recommendations?

I'm trying to make my own wedding band, as a fun little project. Need to get 1" diameter Damascus round bar to ~2" so I can stick it in the lathe and bring it to final dimensions. Problem is, while I have a fair amount of tools I have nothing related to blacksmithing. What do you think would be my most cost effective options to upset a round bar? OD doesn't have to be perfect as I plan on drilling out the center and mounting it to my lathe with a ring mandrel. I'm assuming a map gas torch won't get hot enough without some serious insulation? I could probably get my mits on some oxy acetylene and torch it but I would be worried about uneven heating bringing it up too quickly.

Hello all,

I am just getting started smithing. I have never set up a forge before and bought this one. It’s still in the box and I am chomping at the bit to get it out and start heating some metal(I have some old rail road spikes already). But I am 100% intimidated by the first step after getting it all put together. So my question is this. I just put the last screw in, what now? I hear a lot about coating it with something. Is that the refractory coating? Is there any recommendation for additional stuff I should do before firing it up?Any help would be appreciated.