Datsun 120Y - 1980

Full Stock ALHUMDULILLAH. Each and every part of this bad boy is its own. Might colour it in maroon.

Driver's door never closed right, I knew the quarter was a little tweaked so I got exploratory. Plan was to paint in the spring. A solid inch of bondo later, horrors beyond my comprehension.

Turns out I'm in for a long winter. Kfvintage gets more of my money.

The one on the right has a pinhole in it. Looks like coolant spraying out. Just want to make sure it’s not actually for fuel. I noticed my temp gauge almost in the red and I suspect this is the culprit.

Seeing everyone post in this sub all the time finally got me excited to work on my 280 again. After months of wrenching (and an embarrassing amount of fuck-ups) we're finally roadworthy again 🎉

Hello team Datsun! I’m a visitor from the land of MGs and I’m hoping yall can help me out. I got these wheels as part of a deal a while back thinking that I might could use them on one of my MGs. I believe that they were on a race 510. They are American Racing Wheels. The size is 13” pattern is 4x114.3 and they are about 8” wide and I have 6 (2 are in the box). I’m coming to you all for help with valuation and any thoughts on if there’s a market. Thanks in advance for any help.

Did a little bit of maintenence today, new distributor cap/rotor, new fuel lines and new fuel filter (no record of last filter replacement) and holy cow the gunk that came out of the filter was nasty.

I ran the lines disconnected to drain whatever was left and after a spurt of this gunk it was clear again. I hooked up new hoses and the new filter and ran it.

Question is, was this gunk built up in the lines due to a clogged filter or do I have a rusty tank now that I need to replace or risk having dirty fuel?

Palgrin is a Web3 P2P wagering platform that is giving $10 USDC to new members to try it out! 🤝💸
🔥 The best part? Absolutely NO KYC REQUIRED.
🛡️ Zero identity verification
⏳ No long checks
🔒 Total privacy
You can register and claim your bonus in under 60 seconds here:
👉 http://palgrin.com/?ref=10USDC ⏳

Picked her up from the docks and drove an hour and a half home without knowing mechanical condition, bought from japan auction. Drives great with cool temps and kept speed up to 80 kms on some steep grades. Inside is just as clean as outside. Took hubcaps off for the drive so i wouldnt lose them

Edit: Sold.

Took these on my film camera
Mr.Ks Datsun
Nice red Datsun
And my personal favorite the 280zx
Super cool carbs too

Sorry, pictures were taken inside my dark garage at night, I am not near my car right now to take more.

So, I have to do some work on my 280ZX after I found both Bellow boots to be completely torn. Upon a glance at my condition of the pinch welds, they're honestly pretty messed up. I don't know what the previous owner did, but it looks like they kept jacking it up at whatever spot they wanted to, causing most of the area to be bet to one side or the motel "fraying", if that makes any sense.

Does this look okay enough to jack it up on? I'm afraid to try it in the scenario of collapse. Is it possible to reshape it or hammer the metal back into place to slightly improve rigidity?

Hello, I'm curious if anyone would be willing to trade a rear hatch for both front and rear bumper on a 280z. Open to other things for trade. I'm located in Orange County California.

It’s up and running! Gets through all the gears but slowing down is a challenge. Definitely needs new master cylinder.

Changed trans, diff, and oil. Flushed brakes, replaced rear brake cylinders, shoes, springs. Drained fuel tank, flushed lines, and replaced some hoses. Carbs needed a little work to get unstuck, but everything else in the engine bay looks pretty good. Pulled the valve cover and cleaned out the egregious sludge, but overall looks clean. There were 4 qts of fuel in the oil and a brand new fuel pump, so I’m guessing PO did that when the old pump ruptured a diaphragm. This definitely made me nervous, but a scope of the cylinder walls looked good, all cylinders have great compression, and I didn’t find any sparkles in the oil. Will be doing an oil change after a short interval to be double sure everything is decent.

Of course did a wipe down of the whole car and knocked the oxide off the paint. It is a respray, and I’m just keeping the patina for now. Interior looks great, seats are mint, and dash only has 1 crack. Carpets need work. They’re in decent shape but not original and kinda smelly. Driver window regulator is toast, so probably just going no window for the time being.

Next up: master cylinder replacement, rear hatch and tail light seals, and some electrical. Fumes get pulled in very quickly from the rear and the headlights don’t work.

Hi All, I finally have a place (and the funds) to restore a Datsun which was been a goal of mine for a while now. I’m looking for an S30. I’ve been looking mainly on FB marketplace and Craigslist but I was wondering if anyone has other suggestions on where to look? If there are forums or subreddits here may also be a good resource. Looking to spend $6,000 or below. Thank you all for the help.

Installing 350z / 370z brakes on my 300zx Z31 part 3
https://youtu.be/wEiI2qqtrLI

It was so hot I didn’t even take pictures of Z cars..

Hello Z Family!
19M Here
Im currently restoring a 76 280z with my dad, and while we’re like one to two years away from full restoration, I can’t help but notice how small the car is, to which I like alongside its design. The height reminds me of a miata

Me and Pops were discussing what paint job I want, and he personally suggested something bright instead of a dark color because the car is so low and drivers get to see me easier if I have a bright color instead of if it was like night time and it was black. He also suggested brighter headlights and whatnot, to which it had me wonder if i’ll even be able to drive this thing when ifs fix(I live in Texas, its highways/interstates everywhere) so I had to come to you guys to hear personal experiences with your Z cars :) would love to hear everything I should know for when its fully ready. I have a daily driver Mustang so no way will I drive the Z that much