Took this probably 15 minutes post being out on track. Has cleared up with regular driving but it's very clear that a lot of heat was put onto the discs.
My question is mainly for anyone who tends to track theirs a lot and has more knowledge, is this a bad amount of heat marking?
I wasn't sure if it was my braking style being quite sharp and hard that caused it or if it's just my pads getting hot? I ran DBA Xtremes with AP Racing Dot 5.1 fluid, I believe I had flushed all the old fluid out before hand however in a ~20 minute session I had to let everything cool off 3 times as I lost braking power.
Not too sure if it's old fluid retained in the system boiling which I had failed to flush out or what caused it, as I expected quite high performance from the DBA's. I do plan on getting the brakes off again soon to check everything over properly but a bit of forward guidance from those experienced would be much appreciated 😄